![]() That's what this guide is for!īased on the work of Graham Bland, a member of our community, this tutorial will tell you what settings are worth changing, and why, in order to maximize your CNC's performance. Those numbers can be confusing, and it's hard for even some advanced users to understand what they mean, and what effect a change would have on their CNC. While typing $$ only shows you a list of current settings, but then you can take a setting, lets say (as an example) $110 and type $110=5000 into the console and that will automatically change the setting. Trial and error probably gives you the best setting. ![]() When your laser engraves too darkly, increase the 30 from 1000 to a higher number like 1200 etc. ![]() Back to lasering another import setting is 30, which is the power range of the laser. When you do, you will see something like this: Safe acceleration settings are around 30 mark. To see what your Parameters are set at, you have to connect your CNC to a computer, and type $$ into the console of your CNC controller software, such as Candle, UGS or bCNC. That being said, there are variables within the Firmware called Parameters which can be modified with relative ease by more advanced users to tune their CNC's in order to maximize it's performance. ![]() Much of this is largely set in stone unless the user goes to great lengths to rewrite our Firmware with that from another source. The Firmware, a customized version of the Open Source GRBL in this case, is loaded with safety features and hard limitations on things like maximum speed and acceleration settings which are optimized in such a way to provide as safe a learning experience as possible for our users. If you purchase using a shopping link, we may earn a commission. To keep things this way, we finance it through advertising and shopping links. Learning to use a CNC can be hard enough for customers who have no prior experience with subtraction manufacturing, so we put special attention into something called Firmware which is a semi-permanent software programmed into a read-only memory on the electronics that drive your CNC. GRBL Settings/Configuration: The Basics All3DP This article is free for you and free from outside influence. Here at SainSmart, we do our best to make sure our CNC's are sent to the customer ready to use after some easy assembly and software installation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |